The Benefits of Waterjet Cutting Methods Since the 1950s, waterjet cutting has been around, developed as a way to cut lumber from large trees. Because of advancements and improvements through the year, the waterjet method has been used in many applications in cutting flat materials including stainless steel and aluminum. High pressure stream of water is used for the waterjet method in order to cut or clean materials. The waterjet is usually connected to a high-pressure water pump which releases water from a nozzle which then cuts through the materials at high speed. Putting additives in the form of abrasives helps in the cutting process. Using waterjet cutting has many benefits including some of those given below.
What Research About Waterjet Can Teach You
Waterjet are very power tools. You might not expect it to be one, but they have the ability to cut through as much as an eight inch stainless steel plate and 10 inches of aluminum plate.
Doing Lasercutting The Right Way
Other cutting methods generate high temperatures which is not ideal for cutting materials that are sensitive to it, and so the waterjet cutting is the preferred method. Waterjet cutting minimizes the effect of heat and allows metals to be cut without altering or damaging its surface because this method has no heat-affected zone. Another benefit of waterjet cutting is that its cut is very precise. Waterjet cutting can reach an accuracy of 0.13 mm and repeatability of 0.03 mm. Using waterjet method for cutting is not only precise especially for steel and aluminum, it also provides a burr-free finish. This can save you a lot of money since it eliminates secondary surface finishing in most cases. You can also benefit from the speed of waterjet cutting. Projects using waterjet method can benefit from its speed and efficiency. The reason for this is that it can easily be set up, the cutting process is faster than any other methods, and re-cutting is avoided because waterjet cutting is very precise. Waterjet is also considered green technology. You cannot find any hazardous waste materials when using waterjet cutting method. It also prevents unnecessary waste of resources since large pieces of reusable scrap material can be cut off which is not possible using traditional cutting methods. There are lot of environmental advantages when you use waterjet cutting for steel or aluminum. The amount of water used in waterjet cutting is very little. The per minute use of water for waterjet cutting is only one half to one gallon of water. This amount depends on the size of the cutting head orifice. IF you have a closed looped system, the water used can also be recycled. Since the waste water is clean enough, it can be filtered and disposed of through a drain. Waterjet removes airborne dust particles, smoke, fumes, and contaminants from cutting materials. This greatly improves the working environment and reduces problems arising from the machine operator’s exposure.The working environment is then improved greatly and the machine operator will have reduced problems from exposure.